Serving the Jackson metro like it’s our own.
Serving the Jackson metro like it’s our own.
Measured, Not Guessed
The AC has run since lunch and the front rooms still feel heavy. The thermostat reads 73, but the upstairs is warm, the back bedroom is worse, and the air has that damp, sticky weight to it that a number on the wall never quite catches. Somebody’s been out before. They added a little refrigerant, maybe. It felt better for a week, and then it didn’t.
That’s the Brookhaven story we hear most — an old railroad town of solid homes, some of them Victorian-era and close to a century old down by the depot, others newer out on the edges, all of them fighting the same south-Mississippi humidity. Rooted Heating & Air measures airflow, duct pressure, refrigerant charge, and humidity before telling you what’s wrong. We’re honest that Brookhaven sits at the far south edge of our range — a good stretch down I-55 from the metro — so we plan the trip and do it right the first time, because on this housing stock, in this climate, what’s actually happening inside your system is almost never what the thermostat would have you believe.
How can we help you?
Mission-Driven Service From People Who Actually Care!
South-central Mississippi humidity is relentless, and it does not care what your thermostat says. Dew points hit 72°F by July and morning humidity peaks near 94%. A system that’s oversized — the most common install shortcut around here — cools the air fast, satisfies the thermostat, and shuts off before it has pulled that moisture back out. The room reads 73 and still feels like a locker room. The CDC recommends keeping indoor humidity below 50% for health and comfort; a lot of Brookhaven homes never get close.
The housing stock makes it harder, and Brookhaven has more range than most towns its size. Down around the depot and the older streets near Whitworth, you’ll find Victorian-era and early-1900s homes — tall ceilings, additions layered on over the decades, and ductwork that has been patched and re-patched for as long as anyone can remember. The Department of Energy has found measurable duct leakage in 90–100% of tested homes; a system that loses 20–30% of its conditioned air into a 130°F attic will lose to this climate no matter how good the equipment is.
Out on the newer edges and along the Highway 51 corridor, the homes are younger but the story rhymes — builder-grade duct runs stretched through hot attics, sized for the plan on paper rather than the house as it actually sits. The equipment can be perfectly healthy and still hand back a fifth of what it makes before the air ever reaches a register.
None of it shows up if no one puts a gauge on it. It shows up on the power bill, in the back rooms that never keep up, and in air that feels wrong at the right temperature.
Most HVAC visits in Brookhaven go the same way. The tech hears the complaint, glances at the unit, makes an educated guess, adds a little refrigerant, writes the ticket. If the sticky, uneven feeling comes back in a few weeks, another guess. That’s the cycle the industry runs on. We don’t — and because Brookhaven is a planned trip for us, we come out prepared to measure the whole system in one visit rather than making you wait on a second guess.
Across the air handler — it tells us whether your system is fighting the ductwork or breathing freely. High static pressure is the silent killer of HVAC equipment, and it almost never gets checked.
At the registers — whether the conditioned air the system produces actually arrives where it's supposed to. In an older Brookhaven home with original ducts, the answer is often "no."
At multiple points in the home to establish a baseline. The CDC recommends keeping indoor humidity below 50% day and night — in Mississippi summers that requires a system tuned, sized, and sealed to do it. In Brookhaven’s century-old homes near the depot, tall ceilings and layered additions let that moisture settle in and stay.
Not just a quick pressure check, but a measurement against manufacturer spec. The DOE has found 29–78% of systems run with incorrect refrigerant charge. Nobody catches that without testing.
We retake the measurements and show you the before-and-after. You don't take our word for it — the numbers do.
From emergency repair to high-efficiency installation, duct testing, sealing, and maintenance, every job starts with measurement — so the fix addresses the root cause, not just the symptom.
A 1-year guarantee on parts we replace during service calls, plus an 18-month workmanship guarantee on every install (refrigerant excluded — owner-paid). New installs carry the manufacturer’s equipment warranty — 5 years standard or 10 if we register it at install.
National Comfort Institute training in airflow, static pressure, and combustion — the certification that requires you to actually measure what’s happening in the duct system. It’s why we can tell you what’s wrong before we tell you what it costs.
On an older home near the depot it’s easy to point at the age of the system and quote a replacement. We’d rather measure it first. We’d rather lose the sale than push you toward a $9,000 replacement when a $400 repair would have solved it. The numbers tell us when replacement is the right call. When they don’t, we say so.
Honest pricing. Plain answers. Showing up when we said we would, and treating the people who let us into their homes the way we’d want our own family treated.
We work across Brookhaven — the historic streets downtown, the older homes near the college, and the newer edges out along the highway — and we know where each area’s comfort problems tend to hide:
Victorian-era and early-1900s homes near the railroad depot. Tall ceilings, layered additions, and decades-old ductwork make duct testing and sealing the high-leverage move before anyone talks equipment.
Older established homes near the historic college grounds. Original attic duct runs and undersized returns are the usual culprits behind uneven cooling.
A mix of older homes and newer builds strung along the main route through town. Long duct runs and systems whose static pressure and charge haven’t been checked in years.
Newer subdivisions on the north edge of town with builder-grade duct runs through hot attics. The leakage shows up on a test before any equipment needs touching.
Established mid-century homes where humidity control is often the unsolved problem, even when the AC technically “works.” Right-sizing beats raw tonnage here.
Homes toward the south end of Brookhaven on aging systems nearing end-of-life. Right-sized replacement after duct testing is the play — not a bigger box.
Don't let comfort problems linger - your home deserves better, and so do you!